Rose folding diagrams are as follows:

1, first of all, prepare four small square paper (7.5cmX7.5cm) and a rectangular paper (7.5cmX15cm).

2. First, let's fold the rose's branch, take out the rectangular paper and roll one corner inwards to form a cylinder.

3. Roll the rolled-up cylinder upwards until it reaches this position (don't leave a gap in the middle when rolling, roll it tightly), and apply glue to this corner.

4. Roll the glued corner into the cylinder as well and glue tightly. In this way, the flower branch is folded.

5. Take out a square piece of paper and fold the top and bottom sides.

6. Fold the left and right sides together again as well, aligning them.

7. Fold the bottom right corner along the diagonal to the top left corner and align.

8. Pinch the upper right corner (not split) and use scissors to cut from this position.

9. Cut the upper section into a circle as shown.

10, then cut a small part of the bottom top corner as well.

11, this is the figure obtained after unfolding.

12, the other three will also use the same method of operation, the total **** to get four such flower pattern.

13, will be four flower-shaped respectively, minus 1, 2, 3, 4 petals, as shown in the figure.

14, will be cut off the right side of the 2 pieces of petals and 4 pieces of petals discarded.

15, readjust the position for 1, 3, 4, 5, 6 and 7 petals.

16, apply glue to the two separated petals and stick them back together.

17, and then all the petals will be rolled outward, as shown in the picture.

18: Glue 1 petal to the top of the branch and adjust the shape.

19: Apply glue to the bottom part of the 1 petal on the flower branch, thread the 2 petals from the other end of the branch along the hole in the center, and then glue it in place.

20, and then 3, 4, 5, 6 petals through the top of the branch, glued, slightly adjusted. In this way, the rose is folded.