Making a patterned substrate:

1 Pour an espresso into a cup of any size (we used a 300 ml cup). When holding the cup,

Face the cup handle to your body and tilt it at 45 degrees.

Pour the milk from the coffee center about 8 cm away. Milk will melt into coffee and form a layer of foam composed of Crema and milk foam.

In the process of injecting milk, keep a steady flow rate, and at the same time, the milk flow repeatedly shakes around the cup surface, just like painting a smiling face.

4 When it is two-thirds full (or depends on the formula), put the flower jar close to the coffee cup and create the design according to the steps.

Dabaixin operation process

1. Prepare the coffee base.

2. When the cup is filled to two thirds, lower the cylinder and draw flowers close to the coffee cup. A white circle begins to form on the surface and gradually becomes larger, which is the beginning of making the heart-shaped pattern. ?

3. When the cup is almost full, you will see that a big white milk river circle has been formed on the coffee surface to lift the milk flow, and draw a line with milk in the circle, thus making the shape of a heart.

Leaf-type operation flow

1. Prepare the coffee base. ?

2. When it is two-thirds full, lower the flower drawing jar to the surface of the coffee and continue to draw a white circle on the surface, which will be the foundation of the leaves. Then start swinging the cylinder from side to side during pouring.

3. While you keep swinging from side to side to pull flowers, slowly move the cylinder to the edge of the cup-you should see the leaves slowly forming in the cup.

4. When the flower-pulling cylinder moves to a place close to the edge of the cup, lift the flower-pulling cylinder to a position 3 cm high from the cup surface, and end it with a milk line passing through the center of the whole pattern-so that beautiful and full leaves can be made.

Tulip operation process

1. Prepare the coffee base. ?

2. Keep the coffee cup at a certain angle, like the basic tulip pattern, and inject the first circle in the center of the coffee cup. ?

3. Note the second circle below the first circle, and slowly increase the milk flow in the process of pouring, so as to push the circle upward. ?

4. Continue to inject another layer under one layer of circle until it reaches the bottom of the cup, and the newly injected circle should gradually become smaller each time. ?

5. Lift the flower drawing jar, end it with a milk line passing through the center of all circles, and cluster it to make multi-layer tulips.

Swan operation flow

1. Making a base in a coffee cup, to three?

2. Put the impact point into a large flow and swing left and right to retreat. ?

3. Improve the end of the flower cylinder to make the swan's body. ?

4. Pull up the milk flow to make the swan's neck. When it is equal to the last circle, pull out a small circle and end it with a milk line passing through the center of the circle, thus making a careful shape, that is, the head and beak of the swan.