Many people now use steam mops, which use high-temperature and high-pressure steam to disinfect and sterilize. At the same time, they can easily remove difficult dirt and are super practical. However, during use, people occasionally encounter steam mops that do not release steam. How to solve the problem?

How to solve the problem of steam mop not releasing steam?

If the steam mop does not release air, people first check to see if the water inlet is blocked. When mopping the floor with a steam mop, it is inevitable that foreign matter will block the water inlet, which will eventually cause the main unit of the steam mop to heat up so much that it will stop breathing. To solve it, people only need to remove the foreign matter from the water inlet.

Secondly, people should look at whether the steam mop main unit only makes the sound of boiling water but does not spray out steam. If so, it means that the duct of the steam mop is blocked, and people should shut down the machine immediately, and then use tools to clean the steam duct and the air outlet of the ironing panel.

Again, if the steam mop makes no sound of boiling water and the host does not heat, it means that the inner tank or circuit of the steam mop is faulty. In this case, you need to find someone to repair it.

Finally, if the new steam mop does not emit steam, this kind of people need to go to the after-sales service. The new steam mop is still within the warranty period. If you can find an after-sales solution, of course you should go to the after-sales service.

How to solve the problem when the steam mop automatically cuts off the power due to lack of water?

The steam mop automatically cuts off the power after being used for a period of time. People may have forgotten to add water or the water in the mop has run out. In this case, just add water in time.

If it is not a lack of water, the fuse of the steam mop may be blown. If the fuse blows, people can just reconnect it.

If neither of the above two situations occurs, there may be a problem with the circuit board and other parts of the steam mop. In this case, it is recommended that people loosen the steam mop to a repair center instead of repairing it themselves.