not much to say, let's first
↓ an example of a pipe template ↓
↓ and then look at the details ↓
1. Steel plate is used as the base of the bracket when making the bracket, which will not cause the phenomenon that the bracket base is half bright and half dark when painting powder or decorating the surface.
2. When the portal bracket is at a 911-degree angle, it shall be welded with 451 chamfers, and it shall not be cut completely when the section steel is cut at a 911-degree angle. The whole angle shall be turned by gas welding, and then it shall be welded with electric welding.
3. Computer simulation technology of pipeline comprehensive balance is adopted to realize centralized distribution of pipes and unified supports.
↓ Centralized pipe distribution and unified support ↓
↓ Appreciation of support practice example ↓
Key process: steel plate base should be adopted for wall pipe support base.
↓ Appreciation of engineering examples ↓
1. Change the interface of insulation board along the pipeline direction from 911 to 311~451 cut adhesive connection, thus increasing the adhesive contact surface by 1.4~2 times.
2. At the thermal insulation interface of vertical pipeline, a layer of the same thermal insulation layer with the width of 111~151mm is wrapped to improve the weak link of thermal insulation at the interface.
3. The corner of 911 square air duct insulation is assembled at 45 degrees. When the insulation board is cut at 911 angles, don't cut through it, reserve 5mm thick for the whole corner, and then use glue for flat-fell seam.
↓ Interpretation of the method of metal protective shell for pipeline ↓
Measuring blanking and making dies at elbows
Mechanical flanging
↓ ↓? ↓
bend the arc along the pipe
↓ ↓? ↓
Installation and fixation (riveting)
↓ ↓? ↓
fabrication and installation of flanges and brackets
↓ ↓? ↓
Identification and finished product protection
↓ ↓? ↓
↓ The finished product project is beautiful ↓
After reading Xiao Bao's article, I hope you can all become the "siege lions" of Niu Magnificent!