The use method of transfer printing sticker is: cut the pattern to be used, then stick the pockmarked side on the model smoothly, and scrape it back and forth on the front of the sticker with a scraper.

1. Soak the printed water transfer printing paper graphic in water for 30 seconds until the pattern can slide on the paper.

2. Clean the surface of the pasted object and wet it with water. Take out the soaked water sticker, aim at the surface of the pasted object, and gently rub the film on the surface with your left hand to shift the paper film. The correct backing paper will be exposed. At this point, the right hand pulls the backing paper and the left hand holds the exposed film. Slowly twitch the backing paper with your right hand until the backing paper is pulled open.

The image may have internal blisters or slight deformation, which needs to be fixed. Move the image to the desired position and fix it. Squeeze the moisture under the dry film with rubber sheet or sponge cloth, pay attention to the method, scrape the nearest edge, and don't use too much force at first, so that the pattern can be completely attached to the surface of the object.

3. Drying: it can be baked at 80 degrees 15 minutes or naturally dried 12 hours, and the positioning film on the surface can be torn off.

Pressing stickers, also known as transferring stickers, generally refers to one of the stickers used to beautify models in the model industry. The appearance is a transparent plastic sheet with a pattern, usually with a piece of paper to protect one side of the sticker. Place one side of the sticker on the surface of the model, scrape the back of the sticker repeatedly with a hard object (such as a coin) or press it hard until the sticker is printed on the pasting place.