How to use the Bear Juicer? How to make strawberry milkshake?

Ingredients

About 10 strawberries

A box of yogurt

A juicer

An appropriate amount of purified water

Method/Steps

First, wash and cut the strawberries into pieces, open a small opening in the yogurt, and prepare the juicer (the Bear juicer is used here)

The reason for cutting into pieces is to put more strawberries in it~because the bottle has a capacity limit for juicing~

Please click to enter a picture description

Please click to enter a picture description

Add half of the strawberry chunks into the juice bottle, then pour all the yogurt, shake the bottle, let the yogurt fall between the strawberry chunks, and finally add the remaining strawberry chunks.

Please click to enter the picture description

Please click to enter the picture description

After adding, please check whether the total height of the food exceeds the maximum scale of the bottle capacity.

Please click to enter the picture description

Then install the juice bottle.

Screw the bottle cap with the screwdriver onto the cup, tighten it and turn it upside down. To shake the cup, be sure to let the food fall to the side with the spiral knife before proceeding with installation~

Please click to enter a picture description

Please click to enter a picture description

Next, install the cup onto the juicer. The specific method is:

Align the silver triangle pattern on the bottle cap with the unlocked pattern at the interface between the juicer and the bottle. If aligned, the bottle should just fall into the juicer. Then press the bottle and turn it clockwise. You can feel that the bottle is tightly connected to the juicer.

Check method: After it is clamped, pull the bottle upwards until it cannot be pulled out.

Please click to enter the image description

Then plug in the juicer and you can juice!

The method is: press the button on the side of the juicer with one touch, and hold it down for no more than five seconds at a time. The food should be completely blended within ten times! Please watch the video for details~

Unplug the power and turn the juice bottle in the opposite direction of installation to remove the bottle~

Please click to enter the picture description

If you want to carry it out, you can unscrew the juice bottle cap and replace it with an ordinary bottle cap~

Please click to enter the picture description

The replaced juice bottle It’s best to rinse the cover with water immediately!

Please click to enter the image description

Making strawberry milkshake with the Bear Juicer is so simple and easy to operate!

END

Notes

If you don’t like the sticky taste, you can add water appropriately~Be sure to add purified water~

Pay attention to the bottle The maximum capacity of food marked on it~

Be sure to let all the food fall to the side with the spiral knife before juicing! Otherwise it will cause idling!