Light box signboard, also known as light box billboard, is a billboard made of plexiglass and equipped with daylight tube or neon tube, which is mainly used to display advertisements in glass. So where should the light box sign be installed?
Generally speaking, light box billboards are mainly installed outdoors, such as roads, streets, cinemas (theaters), exhibitions (sales meetings), commercial downtown areas, stations, airports, docks, parks, etc. Are all appropriate; In addition, with the development of ultra-thin, quiet and environmentally friendly light box billboards, small ultra-thin light box can also be used indoors, including some large supermarkets, hypermarkets, banks, beauty salons and buildings. And the advertising effect is very good.
Second, how to install the light box billboard
Light box signboard is a good billboard with good advertising effect, but the installation of light box signboard will be more troublesome than ordinary billboards. The following is to introduce the installation method of light box signboard for everyone:
1. Determine the installation location.
Firstly, the installation position of the signboard of light box is determined, and the installation method is determined according to the actual situation and the type of light box.
Step 2 measure the size
According to the position of the mounting hole on the back of the light box or the actual size of the site, the fixed point for mounting the light box is determined.
Step 3 repair the light box
Choose different methods according to different walls: aluminum-plastic plates, wooden plates and iron plates can be fixed directly with self-tapping screws; Cement or brick wall needs to be punched with an impact drill first, and then fixed with expansion screws; For ceramic tile, marble, glass and other walls, it is necessary to drill holes in the surface with a glass drill, then drill out the expansion screw holes, and then fix the light box or use glue; Some light boxes are hung or hoisted. After selecting the installation position, according to the actual size of the installation hole of the light box, determine the fixed point for installing the light box, then install the pendant and connect the ground wire.
Step 4 connect wires
The outlet end of the power cord of ordinary light box is at the back. When the power supply is located at the back of the light box, cut off the power cord plug and connect it directly, and fix the power connector with insulating tape. If the power supply is installed outside the light box, connect the outlet of the light box power supply to the edge of the light box, and then plug the three-phase plug into the provided power socket.
Step 5 adjust the light box
Open the upper cover of the light box, drill the power cord on the base of the light box with an electric drill, reinstall the power cord, and adjust it horizontally and horizontally so that it can be installed at a fixed point.
Step 6 turn on the power
Clean the surface of the billboard of the light box and turn on the power to use it.
Three. Matters needing attention in installation of light box signboard
1. When the signboard of the light box is large in size, there needs to be a supporting structure inside.
2. If the billboard of the light box is acrylic board, it is best not to fix it with screws, but with special glue or panel.
3. There should be cooling holes on the side of the light box.
4. When installing the light box billboard, try to choose a better installation and removal method to avoid trouble later.