1. First, cut the Sprite bottle from the middle and the top, as shown in the figure.

2. The upper section is reserved for standby, and the lower section is evenly cut into eight parts at the incision, not too precise, but not too far. Don't cut it too deep, just an inch or so. After cutting, it looks like this.

3. Cut each copy like this, and cut a small piece like a shovel. Be careful not to cut below.

4. Cut small pieces into leaf shapes

5. Press the blade to finish the effect.

6. Make other pieces in this way.

7. Remember not to cut the bottom. Oh, it works, too.

8. Cut into leaves at a lower position, so there are two layers of leaves.

9. Treat the remaining small pieces a little. In the picture, they are cut into long needles.

10, it's almost done after cutting, and the work is all on scissors.

1 1. Put the finished bottle bottom on the reserved Sprite bottle.