The first, two-finger winding method

1, playing a coil, the two ends of the line in parallel to press the hook shank, towards the bottom of the hook to leave 3 ~ 4 cm of line, and hand pinch the two sections of line and hook shank.

2, the other hand extends the index finger and middle finger, the coil will be propped up, from the tip of the hook from the bottom of the hook, the hook shank around, two fingers under pressure around the hook shank to continue to circle, winding 4 to 6 turns, continue to pinch the fingers of the fishing line and the hook shank.

3. Use pliers to pull the thread at the bottom of the hook and yank it down, then yank the thread at the shank and pull it up gently to make sure the threads are tightly tied together, cut off the excess threads at the bottom of the hook, and tie another hook as described above, and then complete the double-hook tying.

Second, the hook shank winding method

1, the line along the hook shank towards the bottom of the hook parallel, the remaining about 6 centimeters of line, upward pressure on the line and the hook shank, the bottom of the hook to leave a tongue buckle.

2. Wrap the remaining line from the hook shank to the bottom of the hook, pressing down on the line and the hook shank, and start wrapping around the line about 5 to 8 times.

3. Stick the thread out of the leftover tongue, pull on the thread, and gently tug on the thread at the hook shank.

4, turn the coil of fishing line, pressing the groove at the hook shank, and then use pliers to pinch the thread at the bottom of the hook, pulling hard, single hook tying is complete, another hook can be operated in turn.

The third, the first circle after the knot method

This method is the first of many anglers to learn the hook tied tied method, the operation is very simple, a **** need three steps to complete the tied system.

1, along the hook shank, the line will be wrapped around the hook shank, small hook winding 4 circles, large hook winding 6 circles, the bottom of the hook at the end of the line left about 4 cm.

2, close to the hook shank at the line, playing a pair of pressure coil, will be set from the hook point, so that operation, through the two coils, be sure to press the bottom of the hook head of the line.