Material preparation: Ribbon, scissors, lighter.

Operating steps:

1, first make the petal part, the ribbon is also divided into the front and back, and the front is the smooth side. Fold the ribbon with the back facing up and the front facing inward to form a triangle, then fold a small triangle on the big triangle, sew it with a needle and thread, and do the same at the other end, and make 15 petals in the same way.

2. Then make the part of the flower bud. The flower bud is made of 3 petals. Turn the sewed petals upside down, squeeze the hot melt adhesive on the left, put the flower stem on it and roll it in the middle quickly. Squeeze the hot melt adhesive on the right, roll it up quickly, find a good position and stick the second and third petals on it.

3. After the bud is made, it can be used as the bud part. Stick the remaining 12 petals together with hot melt adhesive, one for pressing, and the radian will naturally form after sticking, and then squeeze hot melt adhesive on one end to slowly roll up the flower.

4. After the bud part is completed, the leaf part is made up of five pieces, which are divided into two sides just like petals. The reverse side is folded in half, and one end is folded in after folding. After folding, squeeze a little hot melt adhesive in the middle of two small triangles, and then pinch them to stick together. The other four pieces are the same.

5. When the leaves are shaped, sew them together with a needle and thread, squeeze a little hot melt adhesive on the roots of two leaves, and pinch them to stick together, so that the leaves are also completed.

6. Finally, put the flower stem through the small hole in the middle of the leaf. The bottom of the flower is covered with hot melt adhesive. Push the leaf up quickly and press it to stick the leaf and bud together.