When planting fingered citron, it is suggested that the sprouted seeds of fingered citron should face upwards. Specifically, the sprouting end of fingered citron should face upwards, and the handle of fingered citron should face downwards, and it should be vertically put into a pot or garden, and then the periphery of the melon should be filled with soil, and the top of the melon should be covered with 5 cm thick and slightly compacted. When the diameter of the nutrition bowl is about15cm, the oblique planting method can be adopted, and the sprouting end of the seed melon is put into the bowl obliquely upwards, and then the periphery and the top are covered with soil. Oblique planting is more conducive to the root system to tie down than direct planting, and the seedling emergence is faster; If the nutrition bowl is large and its diameter is more than 20 cm, if flowerpots are used to raise seedlings, the flat planting method should be adopted, and the melons should be placed flat in the bowl filled with subsoil, paying attention to the fact that the germ is facing up, and the surrounding and top are still covered with soil according to the previous method. Compared with oblique planting, this method is more conducive to the growth and development of seedlings, and it is not easy to get water in the management process because of the change of the crack direction of melons, thus greatly reducing the chance of rotten melons and obviously improving the seedling rate. It should be paid special attention to that when planting melons in pots, under no circumstances can the sprouting end of the seeds be turned down and the handle of the melons be turned upside down. In this case, the phenomenon of rotten melons and rotten seedlings increased obviously, and the emergence rate was greatly reduced.