Step 1: float the tip flat and the double hook is off the bottom.

We trim the lead skin and push the float, so that the lead pendant and the double hook are off the bottom and the float tip is exposed to the water. At this time, it is to adjust the eyes and level the water.

We need to pay attention to one thing here. When we say that the eyes are flat, we don't mean that the floating tip is a little above the water, and the line of sight is good, and the floating tip is half an eye above the water.

If the line of sight is not good, it is ok for the floating tip to be exposed to the water 1 mesh, even if the floating tip is exposed to the water for 2 meshes, it can also be regarded as leveling water, and it is not necessary for the floating tip to be exposed to the water for leveling water.

Step 2, hook the bait with a single hook for fishing.

When leveling water and fishing, a single hook is used to hang more bait, and it is not necessary to weigh the bait, so that the fishing result is more accurate and the operation is very simple.

Rub a bait ball, hang it on the hook, and then throw the fishing group into the water. The float will be dragged into the water, and then the float will be pushed up until the floating mesh above the water surface is greater than 1 mesh, then the hook has touched the bottom.

Then we continue to push the float and want to catch a few eyes, just catch a few eyes above the water.

If we reserve 1 mesh when adjusting the mesh, then after the bait is attached to the single hook, the float should be pushed up, and the float tip should be larger than 1 mesh when it is exposed, and then it is the hook that touches the bottom.

Leveling the water basically completes the fishing. Another invisible advantage of this method is that the bait is not needed at all, and the bait ball can be heavier and larger, but it should not be too light. If the bait ball is not pressed and floated, it is even necessary to add lead wire to the hook to increase the weight of the bait.

However, this method of drift adjustment is not without its shortcomings. This method of drift adjustment, the whole fishing group is weak, and at most, it can only be hooked to the bottom and hooked to the bottom, but it can't be more blunt. It is still slightly insufficient when it is used at a high current speed.