The tutorial is as follows:

Leave a thread about 80 cm before the hook, then lock the needle 16 (the number of needles here is the width of the bag, which can be adjusted flexibly), and turn the hook back and forth. 1 line: a line of short needles without adding or subtracting hooks.

The second line: take off the half needle without adding a line of short needles and without reducing the hook; Line 3-32: Repeat the shackle in line 2. The number of hooks here determines the height of the bag, which includes the height of the bag mouth, bag bottom and bag. The number of rows can also be flexibly adjusted, but an even number is needed.

Then add 1 and the marked buttons on the 7th convex bar on both sides from left to right, and then add 1 and the marked buttons on the 7th convex bar on both sides from right to left (as shown in the following figure). Then, we put the hook on the side, leaving a thread with twice the length of the side, and then cut it off.

Then we hook the belt, just like the hook method of the bag body, 1 line: a line of short needles does not add or subtract hooks; Line 2: 1 lock, turn over, take off the half needle without adding a row of short needles and without reducing the hook; Repeat the hook method in line 2 until the packaging tape reaches the required length.

Then, fold the surface of the bag into the shape of the bag, and the section between the two marks in the middle is the bottom of the bag. The total length of the strap we hooked includes two side plates of the bag.

So when we hook the strap, we have to remove the length of this part, and the remaining length is the length of the strap. Then we sew both ends of the bag to the side plate of the bag with the remaining thread. We can use the bag without treatment, or you can install a zipper. In this way, the small messenger bag with simple hook method is completed.