1. First, make and install USB flash drives on other computers. The method is as follows: Double-click the downloaded USB flash drive manufacturing tool and insert the USB flash drive used to install the system into the USB flash drive. Note that the size is above 4GB. Then select the U disk and click a key to make it a U disk startup disk;

2. Then pop up a warning, format the USB flash drive, and click OK to continue. Then slowly wait to read the progress bar below until the USB flash drive startup disk is successfully made;

3. Successfully make USB flash drive with one key. Click Yes to simulate USB flash drive startup test.

4. You can see the simulation status display after the USB flash drive starts the computer. Normal display means successful production. Continue to the next step;

Step 5 place. GHO file in the GHO folder, which is the gho image of the system to be installed. Can be downloaded online;

6. As shown below, this is the GHO folder after putting away the system GHO image;

7. Restart the notebook, pay attention to the screen prompts to enter the bios settings, and then set the security to disabled; After confirming that traditional support is enabled under the system configuration;

8. Select the startup tab and set it as USB flash drive startup. Finally, select the exit tab, select the ExitSaving Changes command, enter y, and confirm to save and exit.

9. After entering the USB flash drive startup interface, enter 5 to enter diskgenuis；;

10. Select the hard disk to install the system, click Quick Partition, click mbr, select the required number of partitions, and adjust the size of each partition. You can check that the alignment partition is an integer multiple of the number of sectors (ssd hard disk must be checked), click OK, and then restart the computer.

1 1. Enter 1 to enter PE after re-entering the U disk startup interface;

12. After entering the WINPE system, click the "Ghost Backup and Restore" tool and select "Simple Mode";

13. In the new window that pops up, click Browse to find the prepared one. Gho file After selecting the gho file, check "I want to restore the system", then select the system installation directory and click "Restore the selected partition", as shown in the figure:

14. Click the "Yes" button in the pop-up prompt box, and the system installation will run automatically.