How to make coal slime? How to make coal slime in a simple way?

Prepare the required materials: glue, borax, shaving foam, glycerin, water 1. Clean the container, and then add glue to the container as needed.

2. Add pure tap water, and the ratio of water to glue is 1: 1. 3. Then there is stirring, and the glue and water should be fully stirred evenly.

4. After stirring evenly. Add shaving foam.

Don't add too much shaving foam, it will be hard. 5. Then add glycerol, which is optional.

If there is no glycerin, put more water. If you have glycerin, you need to add a lot of shaving foam. You can add more glycerin to make it softer.

6. Then stir. Be sure to stir it until it can be pulled out.

Kind of like cream. 7. Finally, add borax water. Borax water should be used several times in small quantities. Don't add too much at a time if the novice doesn't master it well.

It will harden. PS: The ratio of borax to water is about 6: 1, and the prepared borax water can also be used.

8. Mucus is ready. 9. finished product.

.

How to do simple things in mucus?

Prepare the required materials: glue, borax, shaving foam, glycerin and water.

1, prepare a clean container, and then add glue to the container as much as you want.

2. Add pure tap water, and the ratio of water to glue is 1: 1.

3. Then there is stirring, and the glue and water should be fully stirred evenly.

4. After stirring evenly. Add shaving foam. Don't add too much shaving foam, it will be hard.

5. Then add glycerol, which is optional. If there is no glycerin, put more water. If you have glycerin, you need to add a lot of shaving foam. You can add more glycerin to make it softer.

6. Then stir. Be sure to stir it until it can be pulled out. Kind of like cream.

7. Finally, add borax water. Borax water should be used several times in small quantities. Don't add too much at a time if the novice doesn't master it well. It will harden. PS: The ratio of borax to water is about 6: 1, and the prepared borax water can also be used.

8. Mucus is ready.

9. finished product.

What if the homemade mucus is too thin?

Method 1. For unformed mucus, the method of adding more glue can be used.

Method two. For the finished coal slime that is too thin and sticky, the cover can be left uncovered 1 to 2 days. Pay attention to the preparation ratio of borax water.

Self-made mucus method: basic materials: borax/borax water, glue, (hot water) cold water and other things that can also be used: shaving foam, glycerin (with anti-sticking hands) makeup remover, water turning into snow, foam balls, and some miscellaneous decorations. It's not finished after molding. After molding, add borax water until it doesn't stick to your hands. Too much will be brittle, especially after molding.

Borax to borax water: borax is 1g borax 50ml water. Be sure to use hot water.

The following glycerin water, etc. It depends on the situation. There is no fixed proportion, but it is more or less relative. 100 people have 100 ways to make a kind of mud. Shampoo, lotion, toothpaste, foam hand sanitizer, eggs, bananas, etc. You can put everything (tomato sauce is not allowed, it will be made into tomato juice, hahahaha). Pigment/colorant/watercolor pen core soaked in water/ultra-light clay soaked in water (clay is picked up casually and treated casually). Feel free to put colors, there is nothing written below.

Ordinary mineral mud I: glue+little water (not added)+little glycerin+borax water Ordinary mineral mud II: white glue+little glue (not added)+little water (not added)+little glycerin+borax water fake water: glue+water (1:3 ratio)+little glycerin+borax sponge mud: glue+little water. The longer the time, the thicker the cotton will be. Iceberg mud: glue+white glue (more)+shaving foam+starch/talcum powder+a little glycerin+borax water. Unsealed silk mud: water to snow+water+glue+glycerin+borax water. Expanded iceberg mud: starch+warm water+glue (less)+shaving foam (more)+glycerin+borax water. Don't seal it in a box, blow the surface with a hair dryer.

Steamed bread mud: glue+shaving foam+starch+borax water head table: water+foam hand sanitizer+borax water, put aside to defoam.

How to do it in mucus without borax and baking soda?

The following are the ways to make mucus without adding borax and baking soda: raw materials: starch (a little is enough), a little diluted detergent (detergent must be less), a small measuring cup, salt (4/3 of the small measuring cup), and a little more if there is pigment.

1. Prepare all the raw materials, pour about three-quarters of the salt into a small measuring cup, just a spoonful of starch, and the detergent must be less. If there is, you can add a little pigment and stir until it is like this. 2, then eat, pay attention to let the children wash their hands after playing.

Extended information children's toys shopping tips 1. Look at the packaging. Genuine creative toys are packaged.

Packaging, whether sealed or printed, should be impeccable. If the patterns and words on the package are printed very vaguely, nine times out of ten they are not genuine.

Dachuan's pirated creative toys are not packaged exactly the same. Pay attention to the packaging patterns provided by official website or publicity. If it is online shopping, the pictures provided by everyone are similar, then it depends on the price.

The original and genuine prices will not be too cheap. Since ancient times, there has been a saying that there is gain from giving. 3. About the tail goods.

Many people love to buy junk, thinking it's cheap and good. China is a big factory in the world, and many foreign companies' creative toys have gone to China to find toy factories to process and manufacture them, so it is nothing new to see some irregular defective products.

But as far as creative toys are concerned, the technological content of creative toys is either very high or very low, so it is basically uncommon to have large goods and tail goods. Many tail goods are actually imitation goods or documentary.

Some toy packages are printed with Chinese version, Asian Chinese version and so on. Suddenly it looks like original licensed goods. Check carefully whether there are original trademarks or trademark circles C or R without original authorization.

Many authorized versions have anti-counterfeiting stickers, so we should also pay attention to this. 5. Since June 1 2007, the state has implemented compulsory product certification (CCC) for six kinds of toy products, such as baby carriages, electric toys, ejection toys, doll toys, plastic toys and metal toys, whose quality level directly affects children's health and safety. It depends on whether the above six products are labeled with CCC.