2, the computer version of the soymilk machine is wet, which causes the chip program to be chaotic. The local short circuit of the computer board will also have the phenomenon of button failure. Use a hair dryer to dry the computer board and the water in the machine, or use alcohol to drop a few drops and press it a few times. It is really impossible to replace the computer version intelligently.
3. The light board of the soymilk machine is affected with moisture, which leads to rust or oxidation inside the key, so it is necessary to replace the key or the light board.
4. If the button is not working and the indicator light is not on, please check whether the data cable of the lamp board and the computer version are not connected properly.
Extended data:
Cleaning method of soybean milk machine
1 After using the soymilk machine, wash the internal residue with the corresponding detergent, soak it in hot water for about 5 minutes, and then pour the water. This will remove bacteria and odor from the bottle. Finally, dry it with a clean rag, put it in a cool and ventilated place, and wrap it in a plastic bag for next use.
2. After the soymilk machine is used, take out the slurry separator, and dump the beaten bean dregs when the barrel is not hot. Then gently brush off the residual fibers on the surface with water and a brush. After repeated use, the dirt of the internal electric heater will deteriorate. You can soak in cold water for a while and then brush it with a brush. You can also use a soymilk machine to heat hot water, and you can also remove dirt from the surface.