The newly-built induction cooker is an efficient and energy-saving kitchen appliance. Its advantages such as long service life, simple operation and convenient cleaning are favored by consumers. However, some fault codes may appear during use. The following are some common fault codes and their solutions.

1.E0 code: The controller of the induction cooker is faulty and needs to be replaced.

2.E 1 code: the over-temperature protection function of the induction cooker is started, and it needs to wait for the induction cooker to cool before starting.

3.E2 code: the power supply voltage of the induction cooker is unstable. Check the power supply voltage and start it again after it is stable.

4.E3 code: The temperature sensor of the induction cooker is faulty or has poor contact, so it is necessary to check whether the sensor has good contact or replace it.

5.E4 code: The power overcurrent protection function of the induction cooker is started. Check whether the power supply is higher than the rated power, and then start it after reducing the load.

6.E5 code: The short-circuit protection function of the induction cooker coil is started, so it is necessary to check whether the coil connection is loose and whether the coil is burned.

7.E6 code: The open-circuit protection function of the induction cooker coil is started, so it is necessary to check whether the coil connection is good or whether the coil is damaged.

8.E7 code: The circuit board of the induction cooker is faulty and needs to be replaced.

9.E8 code: The power setting of the induction cooker is wrong and needs to be reset.

The above are the common fault codes and solutions of newly-built induction cookers. Users should pay attention to operating specifications and power supply conditions when using induction cookers to avoid failures. If there is a fault code, measures should be taken in time to avoid aggravating the fault or causing danger.