1 Wrap the bottom of the wine with a towel.

2. Lean the bottom of the bottle against the wall or trees, keep the bottle body vertical to the wall or trees, and press your hand against the bottom of the bottle evenly and forcefully, and the bottle stopper will be pushed out slowly. If there are no walls or trees, you can also hit the bottom of the bottle with your knees or soles.

3. Once the cork is partially ejected, it can be pulled out by hand or pliers. Or you can continue to hit rhythmically until the whole cork is ejected. If you want to open a bottle of carbonated drinks (such as champagne or beer), let it stand still for 10- 15 minutes before opening the bottle.

Second, the family daily wine opening method

You can also try to pull out the cork in the following ways. Try to operate carefully to prevent the cork from cracking. At the same time, make sure that the tools that come into contact with the cork are clean, because dirty tools may cause wine pollution.

(a) pliers+screws

1, take out a screw and a pair of pliers.

2. Nail one part of the screw into the cork and leave the other part outside.

3. Tighten the screw with pliers and pull it out together with the cork.

(2) Cutting tool bottle opening method

1, use a fruit knife or a serrated knife.

Note: the blade should not be too wide or too narrow, and it should just fit into the cork without cutting the edge of the cork.

2, insert the blade into the center of the cork, try to avoid cutting the edge. Hold the bottle neck in one hand and slowly turn the handle to drive the cork to rotate together; Don't turn too hard. Then slowly lift the handle upwards and slowly pull out the cork.

(3) Hook bottle opening method

1, find a hook or thin steel wire.

2. Adjust the angle of the hook or steel wire properly with pliers.

3. Put the hook into the bottle from one side of the cork, rotate the hook, hook the cork and drag it out.

Note: it is best to wear a pair of gloves when operating, so as not to scratch your fingers with the hook.

(4) Shoe opening method

1, find shoelaces or other strong ropes.

2. Tie a knot at one end of the belt.

3. Bring the tape into the bottom of the cork with a strong steel needle.

4. Take out the steel needle, and pull out the tape with force to drive the cork to be pulled out together.

(5) Paper clip bottle opening method

1, take two paper clips and a pen. Straighten the paper clip partially and keep the curvature of both ends unchanged.

2. Put two paper clips into the bottle from the gap between the cork and the bottle mouth until one end of the paper clip is lower than the cork.

3. Turn the paper clip and hook the cork.

4. Wrap the other end of the paper clip firmly, extend the pen into the wound part, pull it up, and slowly pull out the cork.

(6) Nail opening method

1, found 5 nails and a hammer.

2. Arrange five nails in a line and gently smash them into the cork.

3. Hold the bottleneck with one hand. The other hand picks up the other end of the hammer, sticks out the nail, drives the cork to move at the same time, and slowly pulls out the cork.

4. Finally, pull out all the nails on the cork. When the cork is about to be completely pulled out, pull out the nail first, and then pull out the cork by hand.

From Baidu Post Bar Berry Bros. & Rudd: