(1) Press the cleaning key to discharge all the slurry in the barrel, and press the stop key.
(2) Add a proper amount of disinfectant with warm water and pour it into buckets, with the same amount of water in the two buckets.
(3) Press the cleaning key to stir for about 1-2 minutes, and discharge the cleaning solution.
(4) Rinse with clear water for 2-3 times and stop the machine.
(5) Turn off the power supply, remove and clean all parts.
A, unscrew the four screws on the side of the liquid valve and remove the liquid valve assembly.
B, take out the pin fixed by the handle, the handle, the valve stem and the sealing ring from the outlet valve in turn.
C, take out the agitator from the freezing cylinder and remove the sealing ring.
Clean all the removed parts. If damaged, please replace them in time.
E assemble the parts according to the reverse procedure of disassembly. Generally speaking, there are two kinds of packaging for ice cream machines, one is pure wooden frame packaging, and the other is carton packaging. No matter which packaging method is adopted, it is to facilitate the transportation and use of the machine. Because the soft ice cream machine generally weighs about 150 kg -250 kg, it is impossible for ordinary customers to carry it by one or two people. Regular cargo terminals will have forklifts for loading and unloading, while some small cargo terminals do not have these equipment and can only rely on manual loading and unloading. Therefore, the machine may be damaged during transportation. The most common thing is that the appearance of the ice cream machine is hit or scratched. I would like to remind customers and friends who buy machines that these collisions and scratches are inevitable and generally will not affect the use of the equipment itself, but serious scratches will have a certain impact on the beauty of the ice cream machine itself. This kind of situation is generally rare, just to remind everyone. In this case, you can negotiate with the freight company or solve the claim.
The precautions of ice cream machine in handling are not to tilt more than 30 degrees. After the ice cream machine is tilted, it should be put into use for a period of time as far as possible. Mainly worried about refrigerant backflow. Once the refrigerant flows back into the compressor, it may damage the compressor of the ice cream machine when it is turned on. This is not a quality problem. Therefore, please be careful not to lay the ice cream machine flat or flat. After the power connection is completed, you can debug the ice cream machine. Please disinfect and clean the ice cream machine before commissioning. Please refer to other related articles for disinfection and clarification.
After the ice cream machine is cleaned, turn on the power supply, turn on the switch of the ice cream machine, the digital tube displays 00, and press the start button (no discharge). At this time, the number on the LED digital display panel of the ice cream machine will change, and the compressor will start in about 5 seconds. Then observe whether the number on the digital tube will change upwards (if it is a temperature-controlled digital tube, the temperature will change continuously), which shows that the uozhe cooling system is running. If there is no change for a long time, it means that there is something wrong with the refrigeration system or the control board circuit. The most effective way to check whether the refrigeration system works normally is to insert the distribution valve body (front raft) of the ice cream machine, take out the mixing shaft, and directly touch the refrigeration cylinder to judge whether the temperature changes when the ice cream machine starts.
If the ice cream machine is cold and normal, you can directly pour the prepared ice cream slurry into the machine for the first trial production. At this time, it is necessary to adjust the hardness of ice cream. The adjustment of soft and hard will be explained in related articles. Only by adjusting the hardness to meet the normal requirements can normal business and sales be carried out.