1, if you have two bottles of beer, you can put one bottle of beer on the table, stick the lid of the other bottle on the first bottle, and then tap the two bottles gently to open it, which is faster and more labor-saving.

2. Open the beer bottle by using the principle of thermal expansion and cold contraction, take out the lighter, burn the beer bottle cap for more than ten seconds, wait for three seconds or wrap the beer bottle cap with paper towel, and then screw the beer bottle cap by hand to prevent burns.

3. pry open the beer lid with the edge of the table. It can be said that this is the simplest method. Just find a hard edge, put the beer lid on the edge of the table, and then press down hard to open the beer, but be careful not to pry the beer bottle into pieces with too much force.

4. An empty hand can open beer with chopsticks, press the bottom of chopsticks on the lower part of the beer lid, hold the upper part of the beer bottle with one hand, press the index finger of one hand on the upward part of the bottom of chopsticks as a fulcrum, and then press the other end of chopsticks with the other hand to open the beer lid.

5. Most methods of separating beer caps use lever principle, so the key is to find a suitable fulcrum and use moderate force. Because of the lever principle, the closer the fulcrum is to the bottle cap, the easier it is to open the beer bottle. In addition, the lever itself should be hard enough, otherwise the cover will break first.

Method of opening beer bottle cap without bottle opener;

1, you can open the bottle with printing paper, fold the paper in half several times as much as possible, the thicker the better, and then open the bottle with a lighter. Plug the folded paper tightly under the edge of the bottle cap, and then pry the bottle cap open as hard as possible.

You may have to try a few more times and keep spinning the bottle to loosen the bottle cap completely. Although this is a challenging way to open a bottle, it will definitely impress your audience. Be careful with your hand, it's easy to cut your hand holding a piece of paper on the bottle cap.

2. The tenon of the traditional door lock can also be used as a bottle opener. Adjust the angle with the door handle of the closed door to apply pressure, and then watch the bottle cap bounce off.

It is a quick and simple way to use a common fork. Use one tooth of the fork as a lever to push the thin slot of the bottle cap up and keep it away from the bottle cap, one slot at a time.

4, use a spoon, the bigger the better, put the small head of the spoon under the bottle cap, put your hand on the bottleneck, and suddenly exert yourself. It's like using a lighter, but it's much simpler and faster.

5. Beat them with a strong pair of scissors and gently put them under the bottle cap, parallel to the crease (the scissors face the bottle). Cut from the small fold and continue to cut around until the bottle cap can be removed.