1.

1. First braid a 2 cm diamond knot, fold a rope in half and braid it. Use different colors to distinguish it in the picture below. First press the yellow rope onto the red rope.

2. Then wind it out from behind the red rope, leaving a loop at this time.

3. Pass the red rope through the loop left by the yellow rope from the front.

4. Tighten and repeat the above three steps to form a diamond knot of about 2 cm, and then form a circle around the knitted diamond knot.

5. Clamp the buttonhole with a clip to make it easier to braid the corn knot.

6. Divide a red rope into four parts, and divide them into numbers 1, 2, 3, and 4 as shown below for differentiation.

7. Line 2 presses line 1, line 3 presses line 2, line 4 presses line 3, and line 4 passes through line 1.

8. Repeat the above steps until you reach a satisfactory length and tighten the braided bracelet.

9. Put beads on the end of the rope, tie the knot and burn it with a lighter to complete the braiding of the bracelet.

2. Cross-braiding the rope: First, prepare the rope to form a 3cm rope loop. Bend one end of the rope from the top and pull it through the loop. Use your right hand to twist the rope loop to the left to form a cross shape. Then stretch another rope through the rope loop from left to right, and pay attention to adjusting the tightness. This will affect the tightness of the bracelet after it is braided. Then use your left hand to twist the rope loop to the right so that the rope loop becomes cross-shaped again. Then take the rope and stretch it through the twisted rope loop. After stretching it, just tighten the rope.

3. Flat knot braiding: Prepare two ropes; tie the prepared horizontal rope into a knot on the vertical rope and tighten it. Pass the knotted rope under the vertical rope and pull it tight. Repeat the above knotting and tightening steps until the appropriate length is made.

4. Diamond knot rope braiding method: Prepare the tools and tie a dead knot to fix it. The right rope goes around the right rope, and the left rope goes through the right loop. Repeat the above steps until you have braided it to the right length and put the beads on it. After braiding, just tie the knot at the end.