Second, the operation steps:
1, refer to the pumpkin drawing in Figure 1, which is similar to a large flower pattern *** 16, copy it on the orange cardboard in Figure 2, and then slowly cut it out to get a "big orange flower".
2. Draw a little at the end of each petal with a pencil. 16 pieces draw a little on average, and then poke it lightly with an awl. If you are skilled, you can poke the hole directly with an awl without drawing. Because the paper is still hard when you use needle and thread later, it will wrinkle when you wear it hard, so you should punch holes first.
3. In order to make the pumpkin plump, we gently roll it with our fingers to bend it slightly inward.
4. String the pumpkins together. Thread the needle and tie the knot. Then, starting from any piece, the needle and thread go through from bottom to top and slowly connect one piece. Remember to pay attention to the order here, which is the principle of symmetry. Take the surface of a clock as an example. 12 points are connected with 6 points, then 3 points are connected with 9 points, and so on.
5. The worn pieces of paper are all connected at one end. At this time, it is good to tie the knot and fix it. The pumpkin is already very stereoscopic. Small thread. We use green cardboard to make a split cylinder to cover it. Cut out the teeth of the green cardboard at will, and then bend it with an awl. You don't have to stick the teeth when pasting, because you have to fold it later and separate it.
6, the small cylinder is the top of the pumpkin, and it is ok to paste it. There are many different expressions on Halloween pumpkins. I chose a relatively simple triangle pattern combination. I should slowly draw and cut off the curved mouth, and put the cut expression on it to make a small pumpkin.