Materials to be prepared: colored paper, scissors.

Specific steps:

1. Fold the square in half, leaving a crease, and then fold it in half. ?

2. Fold one in the middle and customize the width, about 1 cm. After opening, the other side also repeats, based on the intersection with the diagonal. ?

3. Fold the two pairs into a square, and fold the vertex to the intersection of the two pairs, leaving a crease. ?

4. After opening, you can see that the crease is like this. Then, press the yellow line to leave a crease, and the other three corners will do the same. ?

5. Now the crease is like this, and then the middle will start to polymerize according to the crease. ?

6. Look down from above. ?

7. Leave a crease between two points and do the same for the other three points. ?

8. The crease is basically completed. Turn it over and start to converge. ?

9. Polymerize slowly according to the crease. ?

10, convergence. ?

1 1. Fold the bottom up and open it for sorting. ?

12. The rose is finished. ?