Fault maintenance of steam boiler
After adding water to the steam boiler, the water adding indicator light still flashes. The reason for this failure is that the sensor in the water tank may become dirty after long-term cleaning. At this time, you can rinse with hot water to clean the sensor.
When the steam pot is used, no steam comes out and no heat is generated. This may be due to the failure of the heating plate of the steam boiler, and it is necessary to find the nearest official after-sales maintenance point for maintenance in time.
When the steam boiler is in use, the working state is intermittent. This is because the line of the steam boiler is not stable, just tighten the wires and screws. However, when screwing the screw, the circuit must be disconnected to operate.
The steam boiler can be used when it is turned on at low level, and turned off when it is turned on at high level. This fault may be caused by the small main control switch of the power supply, and the problem can be solved by replacing the appropriate switch.
Matters needing attention in use of steam boiler
When cleaning the steam boiler, be sure to clean the internal and external surfaces and keep them clean. Don't spray-wash, as this will easily cause the electrical components of the steam boiler to get wet, resulting in short circuit or leakage.
After using the steamer, be sure to pour out the water at the bottom of the steamer to avoid the electric heating tube and metal surface of the steamer from aging due to moisture. Clean up the dirt on the electric heating tube in time to make it conduct faster.
When the steam boiler breaks down, especially the steam boiler with metal shell, the main power supply must be turned off first, and then the fault should be checked to avoid danger.
When using the steam boiler, the door of the steam boiler should be closed tightly to avoid steam leakage, otherwise it will not only waste energy, but also easily cause accidental burns to users. After use, wait until the steam in the steamer is completely released before taking out the food, so as not to burn people.
The water level of the steam boiler must be checked, whether the electric heating pipe is basically submerged, and whether the steam boiler with artificial water injection reaches the water level mark.
Everyone must pay attention to the use details of the steamer to prevent accidents. Through the above small series, do you understand the fault analysis, maintenance methods and precautions of steam boilers? Steam boiler is one of the common household appliances, so we must master it!