Wash and cut strawberries in pairs and place the cut side at the bottom of the container.

Pineapples are pressed into shape with a mold and lined up around the container. Pressing the mold of the remaining edges, do not waste, sprinkled in the middle

Heat the water and cold weather strip boil until melted (Figure is about 500cc of water, the water rolled about 5 minutes after the melt), turn off the heat and add sugar stirring companion

poured into the container in two parts, because there is too much water, the fruit will float, pour a layer of the first, and then wait a few minutes, the surface of the solidified a layer of film, and then slowly poured in, can not break the film, so do not pour, and then slowly poured, can not be used to make the film. You can't break the film, so you can't pour it too fast and then put it in the refrigerator at the end, it will start to solidify in the cold days below 40 degrees

Finally, you can take off the mold, you can use a small toothpick to make a circle along the perimeter or use hot water to heat up the edges of the container, so that the edge of the fruit jelly will be slightly softened, and then it will take off the mold ~

Or you can put a layer of plastic wrap in the model at the start before you put the fruit in it, but I didn't do it because I was afraid of plasticizers. I was afraid of plasticizer, so I didn't.