The tying methods for fishing lines and rods are as follows:

One, the live knot method

1, the serpentine rope at the front end of the rod tip is tied with a double knot, and the shorter the length of the serpentine rope after tying the knot, the better.

2, the main line at the top of the knot single loop folded to form a double loop.

3, pinch the intersection of the coils of fishing line knot over the rod and pull tight.

4. If you need to remove it, grab the end of the line and pull it outward.

Two, the space bean method

1, the fishing rod on the snake mouth red rope to make a section, find the end of the connection to the rod to take 15 ~ 20 cm folded, this part of the double stranded fishing line were 3 centimeters away from the ends of a knot.

2. After digging out the live button with your hand, put the red rope into the live button and pull it tight. In order to prevent the live button from loosening, you can put a large space bean on the part of the double stranded line.

3, the fishing line set to the fishing rod red rope, pulling the live button when the space bean pushed to the bottom of the live section, when disassembled pull the previous knot can be removed smoothly.

Three, the valve core method

1, the rod tip on the soft tape on the head of a knot, and folded into a semi-circular arc.

2, take a section of the valve core, set the soft band.

3. Thread the fishing line through the loop of the soft band and tie a knot.

4, take the line, back the valve core from the soft belt.

Four, rubber band method

1, the rubber band on the rod body, the set of circles around a few more times in order to fix the rod.

2, wear a valve core or rubber cap on the fishing line.

3. Attach a connecting ring to the end of the line.

4, with the connecting ring and rubber band connection can be.

5, connecting ring method

1, the rod tip of the soft band into a ring, with a line fastened.

2. Connect the connecting ring with the soft tape ring.

3. Remove the connecting ring after fishing.