Installation steps and methods of embedded ceiling lamp in toilet
The square hole for ceiling installation will open a hole where the embedded ceiling lamp needs to be installed, which is convenient for ceiling installation. Determine the position of the ceiling lamp, and the size of the hole corresponds to the ceiling area. When installing, first install fixing clips on the lamps on both sides, so as to prevent the lamps on both sides from being stuck, and install the lamps in square holes or round holes. Connect the power cord, cover the wiring cover, and tighten the bolts for fixing the lamp holder. The number of bolts should not be less than the number of fixing holes on the lamp holder, and the diameter of bolts should match the aperture. For lamps with no fixed mounting holes on the base (self-drilling during installation), there should be no less than three bolts or screws for fixing each lamp, and the center of gravity of lamps should be the same as that of bolts or screws. ? Put the light away and fix it? Fold in half and press the clamping springs on both sides of the lamp and put them into the opening of the ceiling. The inner clamping spring presses against the ceiling. Hold the mask with your hand and gently push it up to clamp it.
Matters needing attention in installation of soundproof embedded ceiling lamp
1. The ceiling lamp cannot be directly installed on combustible objects.
Some families use colored plywood to line the back of ceiling lamps for beauty. In fact, this is very dangerous and heat insulation measures must be taken. If the high-temperature parts on the surface of lamps are close to combustible materials, heat insulation or heat dissipation measures should also be taken.
2. Winding the connecting cable.
The two wires connected to the power socket of the ceiling lamp should be in good electrical contact and wrapped with vinyl cloth respectively, and keep a certain distance. If possible, try not to put two wires under the same metal to avoid short circuit and danger. Before the ceiling lamp is installed, check the cross section of the wire core leading to each lamp, and the copper core flexible wire shall not be less than 0.75mm2, otherwise the lead wire must be replaced. ? The connection between the conductor and the lamp holder, the parallel conductor between the lamp holders should be firm, and the electrical contact should be good, so as to avoid sparks between the conductor and the terminal due to poor contact and the danger.
What we introduced above is about how to install the embedded ceiling lamp and other related issues. We should know something about this problem. We know it's good to buy an embedded ceiling lamp in the bathroom. Then how to install it after purchase is also a problem we need to know. Above, we introduced some installation methods and steps for you, which can be used as a reference for our installation.
Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~