1. First hit a basin of clean water, preferably warm water, not too hot, about 30 degrees. Then throw the Vajrayana bracelet you want to clean into the basin (don't untie the bought Vajrayana bracelet in a hurry, throw the whole string into the basin), and leave him alone when he sinks completely and slowly. Let's soak in 10 for a few hours first.
2. 10 After a few hours or even a day, take it out, and two people grab one end and flatten the diamond string (if you are alone, you can find a board with a nail on your head instead of each other). After flattening, use a wire brush to brush at a vertical angle. When brushing, don't press the brush hard on the beads, but use the same method as we use a broom to sweep the dregs on the bed. This will make the beads rotate and ensure that they can be brushed everywhere. Brush the Vajrayana bracelet around for more than ten times to ensure that the part close to the hand can also be brushed.
3. After brushing, throw the Vajrayana Bodhi in the bracelet back into the basin, and stir hard with your hands to wash off the brushed dregs. After stirring, change a pot of warm water, soak it for several hours, and brush it with a hard brush as in the second step. Actually, it's almost ready here. If you feel unclean, you can repeat the above operation. Little king kong can soak for a while. It doesn't matter. I soaked myself for 40 to 50 hours. The longer the time, the more pulp on the surface will be softened and brushed off. But I think the longer the time, the more cautious you should be when using a wire brush, because I think the hardness of King Kong itself will decrease after soaking in water.
If you feel basically clean, you can take it out. If you buy a few selected ones, cut the rope at this time, put all the beads in the water and observe, leaving those that turn dark red and dark red. Those that are still yellow will jump out, probably chaff seeds. Even if it is only 1, it doesn't matter.
5. Take out the remaining King Kong and put it on a dry cloth, then wrap it up and shake it vigorously, and gently wipe it with your hands through the cloth. This is to throw most of the water on the cloth. When you feel that the cloth is wet, change to another dry cloth and rub the beads flat by hand. After several times, the water on the surface of the beads is basically dry, but it is impossible to completely take out the water stone that has penetrated into it.
6. After finishing, find a container, put all the beads in, and dry in the shade. Many friends say that the oil is put in a sealed bag and dried in the shade. Personally, I don't recommend this, especially friends in the south, who are prone to mildew, because the release of water is obviously slow after brushing oil. When the water is almost dry, you can start reaming with a drill, which has advantages. Before the water is completely dry, the texture is soft and the teeth are not easy to break when drilling. Moreover, after a bead is enlarged, it is basically wetted by hand, which is equivalent to oiling and maintenance.
Attention. Don't let the soaked Bodhi King Kong bracelet blow, regardless of hot air and cold air, as well as air conditioning and natural wind, away from the sun heat source, such as heating, small sun and other equipment, it is easy to crack. If it is dry in the shade normally, Xiaojingang is not easy to crack.
7. Reaming method: (Generally, diamond Bodhi bracelets are not perforated. We only use natural small holes to pierce thin wires, so we all need reaming to adapt to our wires. Many ordinary playmates don't have hand drills, so it's not cost-effective to buy one just for reaming. At this time, we can spend some effort to enlarge the drill by hand. It's best to hold the drill bit firmly with pliers, hold the diamond with your left hand through this glove or cloth, and then start drilling. We need to drill holes at both ends, right here. In addition, it should be noted that when you feel that the drill bit is a bit stuck, don't do it rashly, because the teeth at the bottom or head are stuck, and it is easy to break teeth when drilling hard. So don't be impatient, slowly twist the drill bit back and forth, and naturally smooth that piece.
Question 2: How to clean up the dirty bodhi of the moon and stars? The simple method is to put the handle ring in the household towel, and the towel surface of the towel is washed away. After you put it away, tie your mouth tightly and rub it with your hands. Colleagues who are rubbing can learn acupoints by hand, killing two birds with one stone. Rub it for an hour every day (or a longer time is better), take out the bracelet and sew it fine with a bristle brush. How to clean it? This string is really "clean". Please prepare a basin of water and soak it for an hour! Soak, mainly to soak the remaining peel outside soft, and then brush it with a brush! At this time, your string had better be a plastic brush! It looks like it's covered with mud. You can't use a wire brush!
Question 3: How to clean up Xingyue Bodhi? It is suggested to wipe with medical alcohol, which has a good decontamination and sterilization effect. Never use water. Xingyue Bodhi is hydrophilic. If you don't dry it immediately after dipping in water, the water will expand and crack the beads. Don't expose yourself to the sun after soaking in water, or it will crack. You can pay attention to the official account of Miaotang WeChat and get more knowledge about the Bodhi of the Sun, Moon and Stars.
Question 4: How to clean Xingyue Bodhi? It is suggested to wipe with medical alcohol, which has a good decontamination and sterilization effect.
Never use water. Xingyue Bodhi is hydrophilic. If you don't dry it immediately after dipping in water, the water will expand and crack the beads. Don't expose yourself to the sun after soaking, or it will crack.
Amitabha, may you be lucky.
Question 5: How to clean up the dirty bodhi of Xingyue? It is the master who dirties the moon and stars: I don't understand. How can the moon and stars be dusty when they shine outside? Guys, where are you going to get towels? Starry eyes? Look at the original post if you are confused >>
Question 6: How to clean Xingyue Bodhi? It is best to soak in warm salt water for a few minutes, then gently clean it with a soft brush, and then rinse it with clear water. Very clean. For more knowledge of Xingyue Bodhi, you can pay attention to the official account of Miaotang WeChat.
Question 7: How does Xingyue Bodhi clean up dirt in the first month? This is not a trash can! ! ! ⊙_⊙
Don't pay attention to the dirty things in the month (see what dirty things are), just play normally.
Question 8: How to clean Xingyue Bodhi? It is best to soak in warm salt water for a few minutes, then gently clean it with a soft brush, and then rinse it with clear water. Very clean.
Question 9: How to clean Xingyue Bodhi so as not to get wet? If it is too dirty, you can wet it with cotton cloth and wring it out to make it slightly wet. Wipe it with this wet cotton cloth for several times, then wipe it with a dry cotton cloth for several times, and then finish it by hand to let the surface moisture evaporate.