So how should the embedded light box be installed on the wall? Before installation, please carefully check whether the keel seal is firm and lubricated. Sprinklers must be glued together with white tape, and the air outlet must be handled well. When installed on the ceiling, first fix it from the middle to both ends, pay attention to two dimensions, pay attention to the weld position and aligned corners, and pay attention to plane lubrication. After completion, the redundant roof will be trimmed and removed. Go to the website first to see if there are any conditions for installing the keel: that is, the wall is ready, and the carpenter is not qualified to handle and plaster the first finished product. Pay special attention to carpenters. Some must be completed according to our requirements. Opening size of lamp, towel rack, etc. It must be dealt with as soon as possible, and the site conditions must be agreed. The first step is to make a fixed aluminum alloy keel. Pay attention to the smoothness and lubrication of the angle. Connect the flat smoke and ceiling lamp, and first place a wooden chassis. The lower part of the wooden frame must be corrected and lubricated, and pay attention to the level. If it's too low, stick out the bottom. Traces of bookshelves. Pay attention to the height of the keel of the lamp holder, clamp tube and lamp board, which should be firm and stable and not shake.
What should I pay attention to when installing embedded light box on the wall? 1, used for walls, aluminum-plastic boards, wooden boards, ironing boards, etc. , can be directly fixed with screws. ? 2. For ordinary cement walls or brick walls, drill holes with an impact drill first, and then fix them with expansion screws. Because the wall is ceramic tile, then fix the light box. ? 3. For the light box to be hoisted or hung, after selecting the installation position, determine the installation set point of the light box according to the actual size of the installation box hole, and then install the spreader to connect the ground wire. 4. When wiring, if the power supply of the light box is located at the back of the light box, the power cord plug can be cut and connected directly, and the power connector is fixed with a special insulating sheath; In addition to the location of the light box, you can also change the output line at the edge of the restricted area of the power light box, and then plug it into the socket with a phase plug. ? 5. Under the condition of fixing the lamp, open the top cover and fixing point of the light box for installation. 6. Turn on the light and clean the surface of the light box.
The above are some problems of embedded light boxes on the wall. You can have a look.
Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~