Fishing and tying fish hooks is a science. There are various kinds of fishhooks, and the hook shapes of fishhook are also very complicated. It is not easy to tie the hooks well and firmly. Some fishing friends, especially those who have just learned to fish, often have hooks slipping and coming off the line when fishing. The reason is that the fish hooks are not tied firmly and are tied improperly and unscientifically.

I list here the 3 strongest fishhook tying methods for your reference. Each has different advantages. Please fishermen tie the fishhook as needed

一It should be tied tightly so that it will not loosen easily, and secondly, it should be tied with few knots so that it is not easy to damage the thread. The following three are commonly used.

The first method is to circle first and then tie the knot

This method is the first fishhook tying method that many fishing friends learn. It is very simple to operate. *** It takes three steps to complete the binding.

1. Wrap the fishing line around the hook handle along the hook handle. Wrap 4 turns around the small hook and 6 turns around the large hook. Leave about 4 cm of thread at the bottom of the hook.

2. Make a counter-pressure coil with the fishing line near the hook handle, and insert it from the hook tip. In this way, pass through the two coils, and be sure to press the thread at the bottom of the hook. .

3. Use pliers to pull the thread at the bottom of the hook, pull the fishing line at the handle of the hook with your hand, tighten it, and cut off the excess thread at the bottom of the hook. Do the same with the other fishhook. Operation, the two fishhooks are tied together.

The second method, the two-finger winding method

This method is called the fastest way to tie the hook. There was a businessman at the Tianjin Fishing Gear Exhibition who used this method to 1 36 sets of sub-threads were tied in one minute, which was astonishing, and the operation steps were not complicated.

1. Make a coil, press the two ends of the fishing line parallel to the hook handle, leave 3 to 4 cm of the fishing line toward the bottom of the hook, and pinch the two sections of fishing line and the hook handle with your hands.

2. Stretch out the index and middle fingers of the other hand, spread the coil, and wrap it from the hook tip to the hook bottom and hook handle. Press down with two fingers and continue to circle around the hook handle, wrapping 4 times. After ~6 turns, continue to hold the fishing line and hook handle with your fingers.

3. Use pliers to pull the thread at the bottom of the hook, pull it down hard, then grab the fishing line at the hook handle and pull it up gently to ensure that the fishing lines are tightly tied together, and cut Remove the excess thread from the bottom of the hook and tie another fishhook according to the above method to complete the double hook tying.

The third method, hook handle wrapping method

This method is more commonly used among veterans. It’s not that this tying method is easy to use, but that it The fishhook tied with this method is the strongest, and the steps are a little more complicated. However, with this method of tying, there is basically no possibility of the fishhook coming off the line.

1. Run the fishing line along the hook handle toward the bottom of the hook, leaving about 6 cm of fishing line. Press the fishing line and the hook handle upward, leaving a tongue buckle at the bottom of the fishhook.

2. Wrap the remaining fishing line from the hook handle to the bottom of the hook, pressing the fishing line and hook handle, and wind it for about 5 to 8 times.

3. Extend the thread end from the remaining tongue buckle, pull the thread end, and gently pull the fishing line at the hook handle.

4. Turn the coil of the fishing line, press the groove at the hook handle, then use pliers to pinch the thread at the bottom of the hook, and pull it hard. After the single hook is tied, the other fishhook is tied in sequence. Just do it.