Be sure to check whether the line is safe before starting to use the noodle machine, and you can turn it on only after confirming that there is no problem. After the power supply is fixed, see that the dough mixer is working normally, and then proceed to the next step. 　　

Put the prepared flour, water and other necessary additives into the bin, mix the flour and water fully at low speed, and then start the high speed. Directly start the high-speed flour and it will fly outward. Generally, the low-speed stirring time is 3 minutes, and the high-speed kneading time is 6 minutes. During this period, be careful not to take too long to reverse. After the tipping bucket is tilted in place, cut off the dough with a knife, and do not put your hands in the box bucket regardless of reverse or forward rotation. 　

When mixing flour, the ratio of water to flour is generally 55-60/ 100. According to the flour with different gluten (different eating ability), different technology and different product varieties, the amount of water added can be mastered by yourself. When kneading dough, if the dough is hard or the dosage is large, the amount of dough should be reduced.

A, dough mixer safety operation procedures

1, the dough mixer should carefully check the equipment and circuit before starting, and it can only be started after it is confirmed.

2. The reversal time of the dough mixer should not be too long. After the tipping bucket is tilted in place, the knife section should be used, and the hand must leave the box bucket when it is reversed.

3, dough mixer operators in the process of machine operation, can't put their hands in the box bucket.

4. The dough mixer operator should fill the oil hole with lubricating oil every day; Insist on cleaning every day, keep the mixer clean, three

Change the oil once a month.

5. Each dough mixer should be managed by a special person. When the remaining surface needs to be cleaned after maintenance or dough mixing, check whether the power is off before entering.

Line the next operation.

6. If abnormal operation of the equipment is found, the power supply shall be turned off immediately and the maintenance department shall be notified.