Rice cooker is an indispensable household appliance in people's daily life, but some small problems often make people at a loss, looking for the seller to repair is always a hassle, cost a lot of time not to mention, but also delayed daily life. Now let me tell you some common failures and repair methods! So that you can repair yourself at home!

Common failures: plug in the power plug after the power fuse blown;

Reasons and repair methods: may be due to the rice cooker power socket water or rice soup caused by a power short circuit, this situation can be used to blow dry the water in the socket after continuing to use a hair dryer; may also be due to the power socket and the plug because of the long-term use of the surface carbonization will be the surface carbonization. Surface carbonization of its surface carbonized layer resulting in a short circuit, this situation can be used to grind off fine sandpaper, and wipe clean with alcohol.

Common Failure 2: rice cooker does not heat;

Reasons and maintenance methods: deformation of the inner pot or deformation of the heating plate leading to high temperature caused by the burning insurance, this case can be carefully repaired on the inner pot or replacement of the heating plate; for the selection of the rice cooker switch may also be caused by damage to the switch, which should be replaced; it is also possible Because of the internal circuit break, this is only need to find out where the circuit breaks, will be connected to the good.

Common Failure 3: Cooking rice that rice is not yet cooked on the jump;

Reasons and maintenance methods: This failure is generally the thermostat within the permanent magnetism of the ring weakened caused by the temperature, which can be disassembled to check the rice cooker thermostat magnetic ring is broken, if the permanent magnetism of the ring is broken must be replaced with the same type of thermostat, if not broken, just weak suction, which is the same type of thermostat, if there is no break, just a weak suction, which is the same type of thermostat, if there is no break, just a weak suction. If there is no breakage, just the suction is weakened, then you can adjust the thermostat on the thermostat screw, each time to adjust the quarter-turn, adjust a test cooking once.

Common Failure 4: cooking rice;

Reason and repair method: may be the insulation switch of the normally closed contacts sintered and stuck together, resulting in the insulation switch in the rice cooking is still continuing to heat the tube energized, so the rice on the paste, this time, available to a knife to the contacts apart, and then clean the surface of the contacts with fine sandpaper.

Common Failure 5: Cooked rice can not keep warm;

Reasons and maintenance methods: insulation switch may be the normally closed contact surface dirty or erosion, so that the contact resistance is too large, resulting in the contact closed circuit is not possible, the heat pipe does not heat, resulting in the rice cooker can not be kept warm, this time, available sandpaper will be used to clean up the surface of the contact, and plated with a layer of tin, if it is the contact surface, the contact surface will continue to be clean, so rice is paste. In this case, the contact surface can be cleaned with fine sandpaper, plated with a layer of tin, if it is still not heat preservation should be replaced heat preservation switch.

Common Failure VI: rice cooker is always jumping;

Reason and repair method: may be water and rice with improper that is, water is too little, only need to add the appropriate water can be.

Common Failure 7: rice cooker heating for a period of time after the power off, a moment and then automatically energized;

Reason and repair method: the temperature control switch is damaged, just replace the new can be.

I hope that these small methods can help you to solve some of the faults of their own home rice cooker, to master some of the basic methods is still very helpful to our usual life.