1. First, a layer of barbed wire should be hung on the adobe wall, and then cement mortar should be plastered. After the residual ash is cleaned, the putty can be painted for the first time.

2. After the first putty drying, conduct the second putty drying. After the putty is dried for the second time, the wall surface can be leveled and polished, usually two to three days after the putty is brushed for the second time. After polishing, you need to apply white latex twice and dry it naturally in white latex.

Extended data

Matters needing attention in wall plastering construction

1. When painting cement walls, water-resistant putty should be selected. This material is not only waterproof and strong, but also does not need to add any glue during use. Even if it is used for a long time, it does not need to be eradicated, and it can benefit from one construction for a long time, laying a solid foundation for whitewashing cement walls.

2. When scraping water-resistant putty in batches, attention should be paid to controlling the thickness of water-resistant putty, and it should not be scraped too thick, otherwise the problem of cracking will easily occur in the drying process. If the flatness is not very good, it needs to be constructed many times until the wall is flat.

3. When plastering the wall, you can first apply a thin layer of ash to make the cement dense and fill the tiny cracks in the wall. After the wall plastering project is completed, it is necessary to conduct a comprehensive inspection of the wall to see whether the angle of yin and yang of the wall is flat, and clean up the mortar scattered on the ground in time to avoid room ground pollution.