Addition and subtraction standard:

Deceleration: braking controls speed, and shifting: actually, it is stepping on the clutch.

Acceleration: step on the accelerator to control the speed, and shift gears: actually, step on the clutch.

First gear: control the vehicle speed at 0- 10km/h (if it exceeds 10, shift to second gear).

Second gear: speed10-20km/h (above 20, change to third gear).

Third gear: the speed is 20-40km/h (if it exceeds 30, change to fourth gear).

Fourth gear: the speed is 40-60 km/h.

Fifth gear: the speed is 60-100 km/h.

note:

① The intersection shall not exceed 30km/h.

(2) The clutch and the throttle can't be pressed at the same time, but can only be switched.

③ The upshift must be continuous.

④ Downshift does not need to be carried out continuously.

Shift:

First gear: Pull to the left and push forward.

Second gear: Pull to the left and press back.

Third gear: push forward

Fourth gear: back pressure

Operation process:

(1) When a voice command is issued.

(2) Step on the accelerator quickly and increase the speed (30~35km/h).

③ Release the throttle → Step on the clutch → Shift to the fourth gear (back pressure).

④ Release the clutch → Step on the accelerator, speed up (50km/h) for a few seconds → Brake (decelerate) and then step on the clutch, and shift to the third gear (release the clutch after shifting at the intersection).

⑤ Front intersection: After voice broadcast → Turn on the light, slow down and shift gears.

Precautions:

① Both feet must leave the clutch pedal completely.

② The clutch pedal must use the forefoot (it is not qualified to step on it with the center of the foot).

③ In the process of adding four and subtracting three, there should be a slight pause in neutral position.

(4) No stopping.

⑤ It must be more than 30km when adding the fourth gear and less than 30km when subtracting the third gear from the fourth gear.