If you can't pull it out, you can put the mold on the surface of warm water and soak it for a while, about 30 seconds or so. Take it out and wait a little while, turn it, you can take it out, but also remember to make it not too full. To take out, every now and then tap the mold,

If you can, take a knife or toothpick or something like that in the ice cream around a circle, you will be able to take out. (If it is too hard to wait for it to put a while and then take) molds are generally softer, that is, not particularly hard, force can be broken left and right, and then repeated many times to break, molds and ice cream directly on the gap on the fall out at once.

Expanded information:

1, demolding time to be placed for a while and so linked to the mold layer of ice slightly melted some and then the side gently break a little. The ice will melt a little bit, and then you can break the side gently to release the mold easily. Or you can choose to use a knife to cut the edge of the mold and then release the mold. If you release the mold directly and violently, the stick will be broken.

2, the popsicle molds into the hot water surface soak for a while, 1 minute or so, and then take out the popsicle (with the mold), a little bump knocked under the can be taken out, this is the use of hot and cold principle, the contact surface will be melted off the loose, it is natural to take out.

3, can be in the mold in addition to the ingredients of the popsicle itself, you can add something, such as adding a small amount of cornmeal, cornstarch, so that the popsicle can be connected to the stick.