Now people regard decoration as very important, because good decoration can not only make them have a good mood, but also make them have a good living environment. People didn't know what a ceiling was before, but with the development of the times, there are more types of ceilings, such as today's gusset ceiling. Some families may have gusset ceilings, while others may not. Some people want to know the installation method of gusset ceiling. Today, Bian Xiao will introduce it to you. Everyone should listen carefully. Very practical.

Installation method of gusset ceiling

1, the installation of plastic gusset ceiling, the first step is to determine the location of the ceiling installation, that is, the ceiling height. Usually, the ceiling can't be too low. Too low a height will make the space look depressed. After determining the installation height, mark the elevation of the surrounding walls with chalk lines, and clearly mark the baseline;

2, according to the ceiling design, ceiling area to determine the size of plastic gusset plate;

3, determine the keel position line. Because the keel is mainly used to support the modeling and fixing structure of external decorative materials, in order to ensure the integrity of installation, the structural size and position line of the keel are determined according to the panel specifications, and the determined position line is marked above the reference line;

4, the main keel installation. The lifting point spacing of the main keel should be selected according to the recommended design series, and the middle part should be arched, and the height of the keel should not be less than 1/200 of the room span. Correct the position and height of the main keel in time after installation. Pull out the vertical and horizontal elevation control lines, start from one end, adjust the hanging height of the boom while installing, and control the flatness of the dragon skeleton. After the bedding face is leveled, adjust some single keels with bent edges until the leveling meets the requirements. When installing the main keel, attention should also be paid to leaving the exit of the lighting line;

5. Install the boom. The installation of suspenders should meet several requirements: firstly, suspenders should be straight and have sufficient bearing capacity; Secondly, derusting of the derrick should be done in advance; The derrick shall not be more than 300mm away from the end of the main keel, otherwise the derrick shall be added. If it is necessary to add suspenders, it is best to lap weld to avoid the main keel falling off.

6. Install the side keel. The side keel should be installed near the main keel. After the main keel and the side keel are installed, check the smoothness and firmness of the keel;

7. Install the plastic gusset plate. Fix the plastic gusset plate on the keel in parallel at one time and connect it with special connectors. It should be noted that when installing the last board, it should be cut with a cutting knife according to the final actual size, the panel should be slightly bent and loaded, and finally both sides should be sealed with wooden strips.

The above is the installation method of gusset ceiling introduced by Bian Xiao. As can be seen from the above, the installation of gusset ceiling is somewhat complicated, and there are always seven steps. However, according to Bian Xiao's introduction, it is not difficult to install as long as you are serious. In addition, if you don't know much about the ceiling, learn more about it and know what to choose. Ok, Bian Xiao's introduction is here.