What is the reason that the soybean milk machine will not turn? Soybean milk machine can not turn how to repair? As people pay more and more attention to health, soybean milk machine is more and more popular among consumers, but the soybean milk machine will sometimes encounter a variety of problems, more do not mind the soybean milk machine is one of them. The following introduction to the soybean milk machine does not run when what to do.

With the health more and more attention, soybean milk machine is more and more popular with consumers, but sometimes encounter a variety of problems. For example, the soybean milk machine does not turn is one of them, in our use caused a lot of trouble. So, what is the soybean milk machine does not turn?

One, the motor does not run what is going on

1, the linear motor in the machine is subjected to moisture, coil short circuit.

Soymilk machine does not run

Solution: replace the motor with the same model.

2, the relay can not be adsorbed or cut off the foot.

Solution: replace the new machine relay.

3, the continuous use of too long, resulting in too high a temperature inside the motor.

Solution: intermittently turn off the switch and pause the use, so that the soybean milk machine gradually cool.

4, the use of the process of improper operation led to water inside the machine, making the machine inside the microcomputer motherboard short circuit.

Solution: disassemble the soybean milk machine, and use a hair dryer to blow dry the computer board as well as the water inside the machine.

5, Jiuyang soybean milk maker can only heat the motor, but can not turn the reason?

The relay and motor are generally damaged and the soy milk maker does not run.

Two, what is the reason the motor does not run after the machine is fixed?

Many people in the repair of the machine, always say that the machine is repaired, you can use the key motor rotation of the cleaning function tester, but put into the water after the use of the whole soybean function tester, add water does not hit the beans. In fact, we are repairing most of the soybean milk making machine, can not directly put clear water test machine. Why is that, because clear water boiling does not produce foam. Most soymilk machines have two sensors, one is to detect the water level, that is, the longer sensing needle, the other is then the anti-spill detection electrode, the sensing needle is relatively short.

In terms of the working process of the soymilk machine, the tank filled with water level sensing needle detects the water level and sends a signal to the main board to drive the heating rod to heat up the hot water, and then as the water boils to produce more and more foam, which rises as the water in the tank boils. Then, when the foam rises to contact with the electrode that prevents overflow, the electrode that prevents overflow immediately notifies the main board that the hot water has boiled, and if the main board immediately becomes a pot overflow, the main board stops heating the heating rod and sends a signal to drive the motor at the same time, and in the entire soybean milk manufacturing process, the above process occurs several times.

Of course, this is most models. Some of the genuine Jiuyang machines have a water level test pin equipped with a temperature sensor. This machine allows you to test the tester directly with water. This is because after boiling the water to a certain temperature, you can start beating beans with the motor. However, this model is becoming less popular nowadays. Now the manufacturer does not use the temperature sensor to save cost.