The egg beater is a very common household kitchen appliance nowadays. Whether it is cooking or baking, the egg beater plays a key role. Although the egg beater is not expensive, making it yourself is not only environmentally friendly. And it also gives you a sense of accomplishment, so how do you make your own egg beater? Below we will bring you three methods of making your own egg beater, for your reference only.

How to make your own egg beater?

How to make your own egg beater 1:

Materials: disposable chopsticks, batteries, tape, beverage bottle caps, toy motors

Production steps:

(1) First prepare these materials and tools, and then drill a hole in the middle of the beverage bottle cap. When drilling, drill in the center, otherwise the rotation will be unstable.

(2) Then tie the disposable chopsticks to both sides of the beverage bottle cap. Be sure to be symmetrical, otherwise it may be unstable when turned.

(3) Then insert the toy motor into the hole of the beverage bottle cap and try to rotate it to check whether it is stable when rotating.

(4) Then beat the eggs into the bowl and beat them with the prepared egg beater.

(5) A simple and convenient homemade egg beater is made. Isn’t it very simple? It is also very convenient to beat eggs.

Method 2 of homemade egg beater:

Materials: mineral water bottle, scissors

Production steps:

(1) Homemade egg beater Container, first we need to prepare a mineral water bottle.

(2) Then cut off the bottom of the bottle with scissors to the length you think is appropriate.

(3) Then use scissors to make several vertical cuts on the cut bottle, with each cut being one centimeter apart, and cut into strips.

(4) Then fold the strip into the bottle, and a simple egg beater is ready.

(5) Then we started to beat the eggs, first using a beverage bottle to separate the egg white and egg yolk.

(6) Add two drops of vinegar and a little sugar to the egg whites, which will help the egg whites to beat.

(7) Then start beating eggs with a homemade egg beater.

(8) After beating for 3 minutes, the egg whites have begun to turn white. Add a little more sugar and continue beating for 2 minutes.

(9) At this time, the egg whites have been completely beaten into protein bubbles. Even if the bowl is turned upside down, the bubbles will not slide.

(0) After each use of the egg beater, clean it with clean water so that it can be used again next time, which is very environmentally friendly.

Method 3 of homemade egg beater:

Materials: container with lid, motor, can, hot melt glue

Production steps:

< p>(1) Drill a small hole in the center of the plastic cover of the container. It would be better to have a hand drill. If not, you can use a knife or a nail.

(2) Use hot melt glue to stick the small motor on the cover. Pass the motor shaft through the small hole. Be careful not to come into contact with the cover, otherwise it will affect the rotation of the shaft. You can also use universal glue.

(3) Then cut an aluminum ring from the can, drill a small hole, put it on the shaft of the motor protruding from the small hole, and fix it with hot melt glue. Also, be careful not to hinder the rotation of the motor. , the electric motor is the power source of the egg beater, so this aluminum ring is the stirrer.

(4) You can make the shape of the aluminum ring a little more complicated. Making a petal-shaped aluminum ring is not to look good, but to enhance the stirring effect.

(5) A homemade egg beater has been made, and then beat an egg into the container.

(6) Then close the lid of the drink tightly. After the wire of the small motor is connected to the power supply, the motor starts to rotate and the egg beater starts to work.

The above is how the editor brings you how to make your own egg beater? All three ways to make your own egg beater.