Material: cardboard 250x300mm. Rubber band 180mm long (wider).

Tools: ruler, pencil, scissors, marker (selected according to drawing scheme), blade, tape paper.

Exercise:

1, according to the size of the wearer's head, cut the cardboard into face contours.

2. Measure the distance between the wearer's eyes with a ruler, make a subscript meter on the cardboard with a pencil, and make a hole (if you are not sure, make the hole smaller first, and then decide which direction to open after the wearer tries). Finally, trim the eyelets neatly (you can use a blade).

3. Cut the blades on both sides of the mask parallel to the eyes, and cut two slits that can pass through the adhesive tape paper respectively, with an interval of about10 mm. ..

4. Draw a pattern, and draw the required pattern on the mask with a colored pen (use your creativity).

5. First, fix one end of the mask and one end of the rubber band with tape paper, try to tighten it on your head, cut the required length and fix the other end. The adhesive tape must be firmly bonded. It bonds the mask and the rubber band tape together through the slit. Both ends of the rubber band can be sintered to prevent the thread from opening.

6. Just put it on.