Sprite bottle flowerpot, no need to water flowers for a month

The more flowers you grow at home, watering becomes a physical job. Watering the flowers every time is quite tiring. Is there any way to extend the watering time? Just a Sprite bottle flowerpot!

1. Find a large Sprite bottle

Rinse the remaining beverage in the Sprite bottle with water. Choose a large Sprite bottle and tighten the cap.

2. Cut the Sprite bottle in half.

Use a knife to cut the Sprite bottle. Cut from the middle of the bottle to form upper and lower parts.

3. Poke small holes in the bottle cap

Punch a few small holes in the bottle cap. You can prick it with a needle, and then put some water on it to see if the water can pass through. Leaks from small holes. Just enough water to leak out.

4. Pour water into the lower half of the bottle

Pour water into the lower half of the bottle and wait for about 6 minutes to fill it up.

5. Insert the upper part upside down into the lower part

Insert the upside-down part of the bottle cap into the lower part of the water, fill the upper part with soil, and plant flowers. Water will slowly seep into the soil through the small holes to keep the soil moist. If you don't water it for about a month, it won't die from drought!

Cut 1 knife off a mineral water bottle to grow delicious garlic

Do flower lovers like garlic? Flowers love garlic, which is not only fresh and delicious, but also rich in nutrients. In fact, a mineral water bottle can produce pure natural garlic, it’s super easy! Come and see!

1. Find some plastic bottles

Mineral water bottles or beverage bottles can be used. Rinse the remaining beverage in the bottle with clean water. No caps are needed to keep garlic yellow. Set the bottle cap aside.

2. Cut off the upper part of the plastic bottle and insert it upside down into the bottle.

Use a knife to cut off the upper part of the plastic bottle and insert it upside down into the bottle.

3. Pour in water and put 1 head of garlic.

Pour water into the plastic bottle, then put in a head of garlic so that the bottom of the garlic touches the water.

4. Place it in a dark place

Put the plastic bottle in a dark place to allow the garlic to grow yellow, otherwise it will turn green.

5. Harvest yellow garlic in about 20 days

Change the water every 10 days. You can cut the garlic and eat it in about 20 days!

Mineral water bottle scissors can be transformed into a cutting tool in seconds

The spring is very suitable for cutting. Flower lovers should act quickly. Cutting a plastic bottle at home becomes a cutting tool! Rub it together and grow big white roots!

1. Cut the plastic bottle by 1 cut

Find a clean mineral water bottle and cut 1/3 of it. Be careful not to cut it all off.

2. Insert the branches into the foam

Poke a hole in the foam board and pass the cutting branches through the hole, which is more conducive to speeding up rooting. The foam board is smaller than the diameter of the bottle and can be easily taken out or put into the bottle.

3. Put the foam into the bottle

First pour water into the bottle, just 2-3cm high from the bottom of the bottle, then put the foam board into the bottle, so that the bottom of the branch Insert into water.

4. Tape the cutout

Close the upper and lower parts of the plastic bottle, and then tape the cutout.

5. After about 1 week, roots will sprout.

Put the plastic bottle under scattered light. Generally, roots will sprout out after 7 days, and they will be white and thick! Turning plastic bottles into treasure saves money and is full of creativity. Flower friends, come and try it! If you think what Huahua said is useful, share it with others!