2. First, cut a piece of A4 white paper into a square, and then fold it diagonally into a triangle.
3. Fold this triangle in half and flatten it.
4. Then take a step, take a ruler, and mark a 7.62cm point from one side edge of the 90-degree angle.
5. Also mark the point on the long side of the crease. Connect the two marks with a ruler.
6. Fold the paper along this line.
7. Then fold the right corner to the left.
8. Draw a line at the center of the folded shape.
9. Then draw the petal shape and try to make it as symmetrical as possible.
10, cut and open, and a petal shape is completed.
1 1, put the template on the red cardboard. Place it in the center and at least about 1 cm away from all edges.
12, and then draw around the template with a pencil. At the end of each petal, add a circle whose width should be around 1 cm.
13, cut out this shape-including the circle.
14, and then add a gold thread to the edge of the shape.
15, use some 1 mm satin thread and some crochet thread, both of which are gold.
16, cut two lines about 10- 12 inch long and set them aside. Then cut off a 7.5cm wide waste paper board. Wrap the rope around this cardboard until you think it is enough to make tassels.
17, and then take a 25cm long rope and tie it tightly, and the remaining two ends should be equal in length.
18. Take the thread off the cardboard.
19, then place it in the center of another 25cm long line and tie a double knot.
20. Cut off the bottom of the tassel and trim the end to make it neat.
2 1, put the cardboard upside down on the cutting pad or a piece of broken cardboard. Use an awl to add a hole in the center and in the middle of each small circle.
22. Bend the petals of the card upward into a smooth curve with your fingers.
23. Pass the line connecting the tassels upward through the hole in the center. Tie a knot at the end so that the tassel hangs below.
24. Cut a fishing line and tie the center of the line directly above the tassel line, just below the knot. This line needs to be about 70cm long.
25. Add super glue to the tassel knot and dry it.
26. Thread the two loose ends of the fishing line through the sewing needle. Then thread the needle and thread through each hole at the end of each petal, from the inside out.
27. After screwing the two petals together, add a little PVA glue between the two small circles, and then keep them together for a few minutes. Then put on the next petal and repeat until all the small circle shapes are glued together.
28. Tightening the fishing line will make the petals "bundle up". Stick the circles together until the glue is dry.
29. Then drop a drop of super glue on the top hole to improve safety. Dry.
30. Cut a strip from the remaining red cardboard. This belt should be about 1.5 cm wide.
3 1, and then calculate how long it takes to make a ring suitable for the top of the lantern, and then add 0.5 cm.
32. Cut the strip into two just calculated lengths.
33. Then, use a gold paint pen at each front end to make it golden.
34. One of the two made 1 should be placed on the top of the lantern, and the other should be placed on the base of the lantern.
35. You can also add many ropes/threads of equal length as decoration, then glue this edge in place and dry it.
36, roll up to form a ring, and then use tape to fix it.
37. Paste it on the top of the lantern.
38. Then it's time to do the same for the bottom. Wrap this cardboard around the top of the tassel under the lantern and fix the ring in place.
39. Stick the ring on the bottom of the lantern.
40. This beautiful and lovely Lantern Festival lantern is ready.
1, when making large yellow croaker to eat, the first thing to recommend is braised large yellow croaker. You need to prepare a large yellow croake